Title: Manifold resurrection
Post by: tmsmini on April 21, 2023, 03:07:53 PM
Post by: tmsmini on April 21, 2023, 03:07:53 PM
Any suggestions on what sealant to use to try to seal the heated manifold pipe as shown in the pictures?
The pipe was rusty enough that I could not cut threads fully. The fittings tighten, but I am sure I need to use a thread sealant.
I have a number of Loctite products and this Permaxtex stuff along with this other sealant.
I suspect almost anything will do as the pressure is only 13 psi.
The pipe was rusty enough that I could not cut threads fully. The fittings tighten, but I am sure I need to use a thread sealant.
I have a number of Loctite products and this Permaxtex stuff along with this other sealant.
I suspect almost anything will do as the pressure is only 13 psi.
Title: Re: Manifold resurrection
Post by: 94touring on April 21, 2023, 03:36:29 PM
Post by: 94touring on April 21, 2023, 03:36:29 PM
I'd probably just try plastic tape to start unless the threads are really weak. Otherwise any kind of silicon should do.
Title: Re: Manifold resurrection
Post by: MiniDave on April 21, 2023, 05:23:55 PM
Post by: MiniDave on April 21, 2023, 05:23:55 PM
I agree, some teflon tape or pipe dope would be my first choice