Can anyone tell me a part number for the proper type of reamer I need? I know it needs to be 13/16 and the needle bearing has to be installed to support the reamer to do the job. Taking a break from body work and getting the sub frames built up.
Aces,
I borrowed one from a friend, but it looked almost identical to this one (http://www.wholesalepowertools.com/tru-cut-galaxy-13-16-chucking-reamer-straight-flute-rcst-812#.VDwEvxb4KSo).
He had drilled a hole in the end and tapped it to accept a bolt so it could be easily turned. Then he used some thick tape to match the inner diameter of the bearing to be used as a guide.
https://www.fastenal.com/web/products/details/360145-131588?searchMode=productSearch&filterByVendingMachine= (https://www.fastenal.com/web/products/details/360145-131588?searchMode=productSearch&filterByVendingMachine=)
Cheapest one I could find. Should work hey?
Sorry. The link in my first comment was all jacked up. Click the link and it should work now. Looks very similar to the one sold by fastenal. I deal a LOT with Fastenal and they are quality, but definitely one of the most expensive options out there. I've not used the sit eI linked to. It's just the lowest price I could find on the right specs.
Straight flute 13/16 reamer and its long enough.. I'm going to order it and try it
Aces. I sent you a PM last night. Check it before you buy.
Let us know how you make out...I was thinking this was a machine shop only thing but all you guys doing it on your own I might give it a go...
Will do. I'm doing it tonight.